Due to unforeseen production issues out of XRAY's control, the latest batch of composite gearbox pinions (part #385000) are slightly oversize. This was due to slight swelling of the composite material from excess water absorption from the air.
(click to enlarge)
This may possibly result in slight difficulty when installing the ball- bearings on the pinion gear shaft. XRAY recommends using very fine sandpaper to slightly reduce the outer diameter of the gearbox pinion shaft until it is easier to install the ball-bearings.
This problem has been fixed in the following production batch of the kits.
If you have any further questions, comments, or concerns, please feel free
to contact XRAY, or you may post your question directly at XRAY Customer Support Forum at www.teamxray.com.
