xrayxrayHome XRAY homeXRAY X-shopXRAY X-forumRCAmerica
supportsearchcontactguestbooksite map
newsproductsaboutusworldwide headlines
 Part number: # 351108
 Released: Jan. 22, 2014
 
Stock status: 
click to enlarge
(click to enlarge)
CNC-machined chassis made from 3mm high-quality Swiss 7075 T6 aluminum, strategically machined in low-stress areas and anodized to make it as light as possible without affecting strength or rigidity.

Non-essential material below the engine, fuel tank, and differential was removed to allow for the lowest possible center of gravity and optimal chassis flex.

Weight distribution, chassis width, and chassis length have a key influence on the handling of the car. All of these features were incorporated into the design of the chassis.

All screw holes on the bottom of the chassis are countersunk, allowing for a very smooth chassis underside with no protruding screw heads. Fits XB8.

The Swiss 7075 T6 used in this chassis is an extremely rigid aluminum material. After the hardcoating process, in rare cases some small cracks may occur; for example, around openings or on edges where tension in the material is highest. These small cracks are a natural effect and have no negative impact on the performance, reliability, or lifespan of the product, and as such are not considered as “defects.”

Note:
Swiss 7075 T6 is extremely rigid aluminum material and after the hardcoating process in rare cases some small cracks may occur – for example, around openings or on edges where tension in the material is highest. Those small cracks are a natural effect and have no negative impact on the performance, reliability, or lifespan of the product and as such are not considered to be a defect.

Due the nature of the aluminum material and the machining process, it is normal that the chassis may be slightly bent in the longitudinal direction.