 |
 |
| Anti-Roll Bar Rear 2mm (Set) |
|
 |
| |
| Rear Anti-Roll Bar Assembly |
|
(click to enlarge)
|
1. Thread an M3x10 rod into one nylon ball joint (#303450) until 5mm of thread is showing. Then thread another ball joint onto the exposed thread until the assembly is XX mm long and both cups are facing the same direction. Repeat for the other link.
Use pliers to install an aluminum 5mm ball end (#303430) into one ball joint on each assembly. |
(click to enlarge)
|
| 2. Fully insert one end of the anti-roll bar into the small hole of the alum. ball end. Use a 3mm set screw to secure the alum. ball end to the anti-roll bar wire. Repeat for the other side. |
(click to enlarge)
|
| 3. Thread a steel ball end (#302650) into the hole on the front edge of each lower rear arm. |
(click to enlarge)
|
4. Use M3x10 screws and the two anti-roll bar mounts to secure the anti-roll bar assembly in place on the rear shock tower. Make sure that the ends of the anti-roll bar can move up and down freely.
Connect the anti-roll bar to the lower arms by snapping the remaining ball joints onto the ball ends with pliers. |
(click to enlarge)
|
| Instruction Sections |
 |
|
|
|
|
|
|
