xrayxrayHome XRAY homeXRAY X-shopXRAY X-forumRCAmerica
supportsearchcontactguestbooksite map
newsproductsaboutusworldwide headlines

 
How do I mount the rear Anti-Roll Bar with a high rear diff?
click to enlarge
(click to enlarge)
When using the upper differential position on the T1FK'05 rear bulkhead, the rear anti-roll bar wire (if used) may touch the rear differential pulley. The solution is easy. Turn the plastic holders (which secure the anti-roll bar) and mount them as shown in the photo.

  next chapter 
Tips & Tricks
   How do I mount the rear Anti-Roll Bar with a high rear diff?  
   Which differential pulley to use for which car?  
   How to prevent the shock ball joints from popping off?  
   Setting tips for different racing conditions  
   How do I modify the rear suspension arm for foam tires?  
   How should I prepare the chassis for using GP3700 cells?  
   Where can I find setup guidance?  
   How should I clean and relube the one-way?  
   Should I use grease on the doglink coupling?  
   What does changing the rear diff height do?  
   What range of gears can be used on the T1FK05?  
   How do I prevent the spur gear on my T1FK05 from breaking?  
   Are not the XRAY spur gears too soft?  
   How do I prevent multi-diff locking axle disconnection?  
   Rubber Set-up sheet for Carpet